Snowbee XS Spey Lines

2D Spey Lines (62ft Head)Suitable for casting in medium rivers where bank-side vegetation and/or seep sided riverbanks have only minimal impact on the back-cast area.

3D Spey Lines (73ft Head)Suitable for casting in large rivers where bank-side vegetation and/or seep sided riverbanks do not encroach on the back-cast area.

3D Spey Lines (73ft Head)Suitable for casting in large rivers where bank-side vegetation and/or seep sided riverbanks do not encroach on the back-cast area.

1D Spey Lines (51 ft Head)Suitable for Spey casting in small rivers where bank side vegetation and /or steep sided river banks severely limit the back cast area

1D Spey Lines (51 ft Head)Suitable for Spey casting in small rivers where bank side vegetation and /or steep sided river banks severely limit the back cast area

2D Spey Lines (62 ft Head)Suitable for Spey casting in medium rivers where bank side vegetation and /or steep sided river banks have minimal impact on the back cast area – an ideal general line.

3D Spey Lines (73ft Head)Suitable for Spey casting in larger more open rivers, where steep sided banks and vegetation do not inhibit the back cast.

3D Spey Lines (73ft Head)Suitable for Spey casting in larger more open rivers, where steep sided banks and vegetation do not inhibit the back cast.

2D Spey Lines (62 ft Head)Suitable for Spey casting in medium rivers where bank side vegetation and /or steep sided river banks have minimal impact on the back cast area – an ideal general line.

2D Spey Lines (62 ft Head)Suitable for Spey casting in medium rivers where bank side vegetation and /or steep sided river banks have minimal impact on the back cast area – an ideal general line.

1D Spey Lines (51 ft Head)Suitable for Spey casting in small rivers where bank side vegetation and /or steep sided river banks severely limit the back cast area.

2D Spey Lines (62 ft Head)Suitable for Spey casting in medium rivers where bank side vegetation and /or steep sided river banks have minimal impact on the back cast area – an ideal general line.

3D Spey Lines (73ft Head)Suitable for Spey casting in larger more open rivers, where steep sided banks and vegetation do not inhibit the back cast.

In all cases, successful Spey-Casting requires fine line control and split-second timing.The amount of line exposed to the rear of the caster is also of paramount importance.During the concluding moments of a Single & Double Spey or Snake Roll, a 'D' loop is formed alongside and to the rear of the caster. Optimal 'rod loading' is achieved when the 'D' loop is at maximum stretch and the fly line 'Head' and rear taper are almost completely outside of the tip ring. If executed using a perfectly balanced line, this 'intentional hinging' of the rear taper not only improves the potential for narrowing the loop in the forward cast but it also increases both line speed and distance….we call this the 'Optimum Rod-Load Point'.On large open rivers there is normally plenty of room for Spey-Casting and the size of the 'D' loop is not a limiting factor. Spey-Cast your way down a tree-lined river and suddenly there is another Dimension to think about. This situation is made more difficult when the caster uses a line with too short or too long a head and finding the optimum rod-load point is left pretty much to guesswork.The Snowbee development team has tackled this situation head-on and produced a range of lines that are perfectly balanced for Spey-Casting in just about any river environment.1D, 2D & 3D and now 4D – Spey-Casting Lines are each colour-coded, providing you with a choice of specific head lengths and corresponding weights to suit your preferred Spey Rod and Casting requirements.1D Spey Lines (51ft Head)Suitable for casting in small rivers where bank-side vegetation and/or seep sided riverbanks severly limit the back-cast area.